This ‘n’ that

New nos a arm bushings in place. They fit much better than the aftermarket items.

Sand blasting really does a nice job on the small parts too.

Tools to remove the bearings and bushings from the spindles. I use the piece of hardwood on the bottom of the vice jaw and rest the spindle bottom on it.

I ended up using this tool also. The bottom bearings cam out easily, but neither bushing wanted to move.

So I used the hacksaw to relieve the bushing. I didn’t cut all the way through – just about half was was all that was needed and they came out – albeit they were still tight.

Oh yes, still need to sandblast the backing plates.

Leave a Reply

Your email address will not be published. Required fields are marked *