More to clean at the bottom of the windshield.
Especially under the fender lip on the passenger side.
This type of cleaning wheel does a nice job getting the old sealant and surface rust off in more open areas.
Fiberglas mat epoxied in place.
The windshield seal will run right over two body seams – one on either side. I filled them with two part body filler (short tiger hair) that is water proof.
Body filler applied and I’ll sand with 40 grit when hard.
The following day I sanded the three spot to where I have a nice smooth run for the windshield seal. I have a seal coming from Corvette Depot.
Next: Extra trim clips and clean up.