Original style air cleaner in place along with the cold air intake. I’ll pick up a custom flex hose to connect the two a bit later. AC is a problem for a dual snorkel setup as the AC pump is in the way for the passenger side connector for the same side snorkel. Must be a special single snorkel cold air feed. I’ll have to check that out as I plan to keep the AC.
Back to the door – I pulled the front and back vertical window runners and cleaned them up. I gave them a coat of white grease and used chain lube on the roller centre.
This little item was found in the door bottom. It is normally attached to the lower front of the door glass in a special hole made for it. The clip that holds it in place is missing. It is available but not just yet. I checked and the same item on the other window is in place so I’ll use it to get the drivers door back together.
Time to replace the door seal. This screw and two at the rear top end of the door had to be drilled out. The tape didn’t save the paint. I used a piece of split rubber pipe for the back two and it worked better.
Next: getting the door seal in place and fixing the window supports.